Patch biker skull, roll or die, motorcycle biker thermo adhesive patch for clothing customization, 11.5 cm
This thermo-adhesive embroidered patch will beautifully adorn any outfit (jacket, pants, T-shirt ..).
The user manual for thermogluing your patch is supplied with the order.
♥ Tips for the heat bonding of your badges.
► Preheat your iron to the very hot position. Check that your media is resistant to high temperatures.
►Heat the back of the badge with the hair dryer so that the thermo-adhesive part softens slightly (this will allow a better hold)
Position the badge on the garment (bag, cap …) in the desired place.
Protect the patch with a piece of parchment paper (or tissue, or wet paw).
► Place the iron on the badge (without moving and pressing) for 15 to 20 seconds.
If your iron is set to cotton, wait 30 seconds.
► Let the badge cool, without touching it.
► The crest is fixed.
Small tip: Make 2 small dots by hand to be sure that the badge does not move.
If the badge comes off, position your hot iron for several seconds and wait for it to cool down.
To ensure the proper holding of the badge, turn the garment, and on the reverse, proceed to the same steps.